Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktinformation
Customer
Bewertet in den USA am7. Mai 2025
Nice case. Great material and nice texture. Every thing was a bit snug inside. My battery is a 3000mAh so it just barely fits. Because of the battery thickness, I had to route my antenna wire in a strange bendy pattern to get it in there without bulging the seams. The screws are sorta cheap and will likely strip out if I'm going into this thing often (which is unlikely).
George Gilman
Bewertet in den USA am5. Mai 2025
This is a really nice looking case, much better looking than the standard white one. It appears to be 3d printed with a really nice well-thought out design. It does have a couple of screws and bolts but rather than relying on the plastic material to hold the bolts, you are provided with some square nuts that slide into a little slot to meet the bolt. This is an improvement in design IMO over relying too heavily on screws which could easily rip out of the plastic. There are screws to hold the board in place but those are inside and less likely to have issues.My biggest issue is that my 'green' case, as ordered, is certainly not green. The label on the bag is even says 'green' but it is a very obvious red color. The color doesn't bother me but it's not what was ordered and since the bag was labeled, it's a quality control issue at the manufacturer, not a packing and shipping problem.Note that this is just the case. You'll want to likely add board, battery, and antenna to the setup. The stock antenna that normally comes with the Heltec boards will not work well . You could simply have it poking out of the case but the case is designed for a different antenna that will screw down on to the case.The description does not state exactly what battery size will fit, which is a bit troublesome. A 3000mAh battery was shown somewhere so I ordered the same brand and size so I assume it will fit. I've put a board in it already but it was coming from a different case and I only had it powered via USB C.There are no instructions included on how to assemble. Frankly, it's not difficult in the least but it does take a minute or two of looking at all of the pieces an figuring the setup out so it'd be nice if there was an image somewhere that explained how to put it together. It's basically two plastic pieces, the case and a black piece. The black piece looked like a cable relief at first but I pretty quickly figured out it was meant to be the buttons so you slide it into place inside the case. You screw the antenna into the top hole. You put the board in the case with the screen facing the opening obviously, and tighten down screws to hold it in. Then put on the back of the case and add the remaining nuts and small bolts bolts. All simple enough but one diagram would have saved me from having to work it out.
rgr1444
Bewertet in den USA am26. Mai 2025
Everything went together well and it was very easy. It seems to work as it should and it has a big enough battery to last a good time.
JWH
Bewertet in den USA am23. Mai 2025
Case is nice but a bit thick where antenna mounts. Instructions for how to run antenna wire would be nice as the fit is tight and when I ran it as pictured in advertisement on Amazon the case bent as it is really tight. The whole point of getting this as a package though was for the battery and it won't hold a charge. I reached out to seller and will edit review if they come through on a good battery. Picture shows how fast it drops!
WO&BR
Bewertet in Deutschland am 22. Mai 2025
Ideales Gehäuse für Heltec und 3000mAh Akku, sehr gut. Man benötigt eine extra Antenne.
David and Jaqlyn Dillow
Bewertet in den USA am20. Mai 2025
Works but no one in my area. When I travel I test more
Produktempfehlungen