Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktbeschreibungen
731-2643 Schneefräse Schaufel Ersatz für Mtd Schneefräse Schaufel Rutsche Clearing Werkzeuge
Warnhinweise
Achten Sie auf Ihre Umgebung und tragen Sie Schutzausrüstung, einschließlich Schutzbrille, wenn Sie das Werkzeug verwenden. Verwenden Sie das Werkzeug nur auf geeigneten Oberflächen und beachten Sie die Anweisungen des Herstellers.
Reader123
Bewertet in den USA am17. Januar 2025
I like the size and rigidity but the amazon website says there is a template to drill holes, mine has no template. My Craftsman blower has no holes so I was going to drill them using the template. If I knew the recommended hole size I could measure it out. One reviewer (Buckerou) said he cut 21/64 holes on 3 in centers so I will verify. Because of this it gets a 4.UPDATE: I measured it out and verified the reviewer with the recommended hole size/placement was right on so I just installed it using those dimensions; worked great and very tight. I had to pinch the ears together on the retention pin and simultaneously beat the fitting pins thru the hole but it worked good. The seller ought to either provide dimensions for holes or take the note off the web that a template is provided. PS: In 23 years I have never sheared an auger pin but bought some if I ever do. I drilled some holes in the plastic cowling on the blower so I will know where they are and easily accessible IF I ever need; good insurance.
Buckerou
Bewertet in den USA am25. Februar 2024
I've been seeing new snow blowers at the B&M stores all coming with one of these tools attached to the chute. This last snow we had, I definitely could've used one. I decided I'm getting one of these tools before the next snow comes. I ordered the BiLLNE 731-2643 chute clearing tool as it seemed reasonably priced. My old Toro didn't have much of area on the back of the blower, so I attached it to the upper panel. I attached it by drilling two 21/64" holes, 3" apart (center to center) and 1" down from the top of the panel. I had to use a bit of force to get the plastic pins into the holes (but I wanted a tight fit). The end result can be seen in my picture. I'm hoping I don't need to try it till next winter. This is a reasonably priced and essential accessory for all snow throwers.
Dennis Clark
Bewertet in den USA am22. Dezember 2024
Fits great on machine
Mark S
Bewertet in den USA am21. Januar 2024
Bought this for my Craftsman snowblower. It fit the existing holder like a glove. Nicely made and very sturdy.
Laura Martin
Bewertet in den USA am12. Februar 2024
Got to replace a missing shovel on my snowblower. Just snapped in place..no tools needed.
Produktempfehlungen
598.00€
99 .00 € 99.00€