Ihr Warenkorb ist leer
Ihr Warenkorb ist leerattic4twenty
Bewertet in Deutschland am 7. November 2024
Gut verarbeitet
Marcella
Bewertet in Großbritannien am 10. August 2024
Brilliant little baskets, no assembly required.Versatile and great perfor6even with quite a load on them. I used it for lids but I am buying another set for the laundry cupboard.
Kindle-Kunde
Bewertet in Deutschland am 1. Juni 2024
Die SChublade wirkt und ist auch Stabil. Die Schienen insbesondere sind sehr stabil gebaut. Die Befestigung erfordert etwas handwerkliches Geschick, weil man schon genau messen muss, um die Schublade "in der Waage" einzubauen. Eine Angabe über den zwischen den Schienen notwendigen Mindestabstand in der Höhe wäre eine nette Zusatzinfo. So muss man ziemlich rechnen, wenn es mal enger in der Bauhöhe werden sollte.Was man auch bedenken muss ist, dass die Schublade wesentlich weniger Stellfläche hat, als der Boden, den man damit ersetzt. Sie ist um etwa 5 bis 7 cm schmaler und um etwa 4 cm weniger tief. Das fühst schon dazu, dass möglicherweise nciht alles, was man vorher auf dem Festen Boden stehen hatte, nun auf die Schubladenfläche passt.Das lässt sich aber mit der dritten Etage, die man so einbauen kann, wo vorher ein Boden den Schrank in zwei Stellflächen geteilt hat, lösen. Man kann dann eben nicht so viel übereinander auf jeweils einer Fläche stapeln.Insgesam eine zufriedenstellen Lösung, wenn man nicht immer tief knienend Sachen aus einem Schrank herausholen möchte.Kaufempfehlung mit Prüfungsempfehlung zu den Maßen.
Betty
Bewertet in Deutschland am 19. April 2024
Großartiges System, endlich herrscht Ordnung in den Küchenschränken. Stabil und gut verarbeitet, einfache Montage
alan_m
Bewertet in Großbritannien am 5. April 2024
This review is for the CASARI Pull Out Telescopic Kitchen Drawer, 50 Centimetres model. The 50 cm refers to the outside width dimension of the kitchen cabinet. The inside dimension of a 50cm cabinet is around 46.4 cm and the basket and runners fit this smaller inside width. There is some minor width adjustment on the runners so the whole drawer plus runners will fit a width of 46cm to 47cm. The usable part of the drawer is 39cm wide by 43cm deep so you do lose quite a lot of shelf space inside of the kitchen cabinet however, in my opinion, this is more than compensated for by the drawer completely sliding out to the front of the cabinet. No more reaching to the dark recesses of a cabinet to get something at the back, that probably went out of date a year ago. :)The basket and runners are fairly heavy duty and I can believe that the basket could hold 20Kg (44lb), assuming the load is evenly distributed. All component parts appear well made and sturdy.When fitting just plan what you are doing. I suggest remove the door from the cabinet. If you have an existing plastic coated chipboard shelf remove it and place it on the floor of the cabinet. When you later remove this chipboard shelf you will have enough clearance underneath for the basket to slide out on the runners. Place the assembled basket and runners on this shelf with the front of the basket just behind the leading edge of the cabinet. Using the old shelf this way ensures that both runners end up at the same height and the basket is level. Drill a pilot holes through the front mounting holes in the runner(s) and screw it into the side of the cabinet. Then drill pilot holes through the back mounting holes and screw the back of the runner(s) to side of the cabinet. The sparse instructions indicate one screw at the front and two at the back. With the heavily laden basket fully extended the back of the runner will want to rise, hence two screws to support it.You shouldn’t have to remove the basket or runners to drill the holes and screw it in although there is only a small gap in which to get the drill bit and screw in. You may/will have to magnetise the screwdriver to hold the screws when positioning them. Finally slide out the chipboard shelf and discard.If fitting a second slide out basket above one in the bottom of the cabinet again first fit the chipboard shelf, lay the assembled basket and runners on top of this old shelf and repeat the fitting procedure.Fitting two baskets took me around 30 minutes. You will need a drill, a suitable drill bit and a magnetised cross head screwdriver.
oscar
Bewertet in Spanien am 28. Mai 2023
Buena calidad
Bernd R.
Bewertet in Deutschland am 5. Oktober 2022
Passt, hält, stabil. Mutter ist zufrieden.
Agustin
Bewertet in Spanien am 4. August 2022
Ya lo hemos colocado en una despensa y nos ha gustado como queda y lo ordenado que están las cosas ha merecido a compra.
Linda M.
Bewertet in Deutschland am 28. September 2022
Super Teile, kann ich nur empfehlen 👍🏼 Ruck zuck montiert Mein Mann ist Schreiner😉 Hätte ich als Frau aber auch hin bekommen 😅
Nataliya
Bewertet in Deutschland am 22. März 2022
Die Schubladen sind top, seht gute Qualität, einfach zu montieren und super im Gebrauch
N.C
Bewertet in Spanien am 21. Dezember 2022
MF
Bewertet in Deutschland am 18. Mai 2020
Nach unserem Umzug mussten die alten Schränke mit Regalbrettern "modifiziert" werden. Die Montage war einfach, nur das einsetzen der Körbe war etwas knapp, zuerst dachte ich sie passen doch nicht. Mit ein bisschen Gewalt ging es dann aber doch. Man verschenkt natürlich ganz schön Raum, aber das ist halt der Flexibilität geschuldet.
coelner-engel
Bewertet in Deutschland am 20. März 2019
Genau das, was ich gesucht habe. Man kennt ja das Chaos in den unteren Schränken. Da muss man sich schon auf den Boden legen und die Hälfte des Schrankes ausräumen, um an die hinteren Teile zu kommen. Die Schubladenn sind perfekt. Der eigentliche Platz im Schrank wird durch die Schubladen natürlich etwas kleiner, aber das war mir egal. Das Anschrauben ging schnell und die Körbe sind auch viel stabiler als ich dachte. Ich finde die Schubladen perfekt und erfüllen den Zweck, wozu ich sie haben wollte zu 100 %.
Produktempfehlungen