Ihr Warenkorb ist leer
Ihr Warenkorb ist leerMark c
Bewertet in den USA am28. Mai 2024
I received the product and did not use for a couple weeks and then found out. The threads on the handle are so bad you can’t even turn it by hand. Total garbage Chinese junk. Do not buy. I hope the company will contact me so I can return it even though I’m outside the return window.
Customer
Bewertet in den USA am16. April 2024
Made the job so much easier. Just make sure you turn the motor over so it brakes the fins free if you haven't ran your boat in a few weeks.
Ken Kabb
Bewertet in den USA am5. Juli 2023
Bought to remove Yanmar diesel water pump impellers. Center bolt extension is too long. Cut off about an inch so it would reach over the impeller. Otherwise fine.
Ross M.
Bewertet in den USA am2. Dezember 2023
This seemed like an ok impeller puller, but in noted in another review that they thought the center threaded portion was too long and needed to be cut down. In my case, on my very first pull, the body must have deformed before the impeller started moving, due to inferior casting/soft metal of the body of the puller. Caused tremendous galling/spalling at the screw interface. Not good for a first try, on a test pump.Forced apart, with a lot of effort, and recut the threads on both pieces with my tap and die set. Lubed well and tried the next day in the field on a customer boat. Wouldn't grip the impeller and kept slipping. Gave up and went with a different puller. Might be ok if you sharpen the teeth? I just don't trust it.Back it goes...
Produktempfehlungen
64.27€
30 .99 € 30.99€
183.17€
81 .99 € 81.99€