HOJLKLD Türspion, Türspion, massives Messing, 220-Grad-Guckloch mit 28 mm Bohrer für Türen von 3,5 cm bis 5,4 cm, mattschwarzes Guckloch für Zuhause, Büro, Hotel

The fish eye lens is beautiful lens quality. The privacy shutter is riveted in, not screwed so theres no chance it unscrews and falls off. I have no complaints about the quality of this peephole. The included hole saw is also quality and was able to easily saw through my steel door.Some things went sideways on install. Most people will probably be upgrading a peep hole. The drill bit for the hole saw is not the same size as a peephole. This would work great if youre a pro installer or installing a peephole in a fresh door. Installing it into an existing peepholes hole, I anticipated the bit to wander. So wrapped the drill bit shaft in paper then electric tape to try to take up the slack between the door's hole and the bit. To guide my bit straight. I then used my slowest speed drill to start the actual hole saws groove. Once the channel is started it should guide the holes saw. I then switched to a high power drill. My drill was too high powered and I didnt take up enough slack with the tape and paper. So the torque made the drill jump and slightly damage the door finish around my new hole.This had me a little stressed. My drill runs so fast it buzzed all the way through the foam core in a second. Here is where I should have been paying more attention and started checking the hole for straightness with a spirit level and engineers square to verify the hole is positioned absolutely correct. But I didnt and committed to zipping through the outer steel shell.It would be nice if the inner bezel was just a little bigger to hide my initial mistake. But you can kind of see it around the edge of my inner hole, if you study it close. I tried to match the paint with a can of appliance paint. But the match is just ok, since I didnt add a little bondo or primer on the mistake then sand then paint. I went straight to paint. The 3rd rookie move. If you study the lens view close, you can tell its slightly canted up. Due to the mistake of not studying the second penetration before I committed. I removed a door knocker on the outside of the door. So theres a screw hole thats there no matter what. This door probably needs to go to bondo and paint, Just based on that screw hole that attaches the bottom of the old peephole/knocker, if it wants to be alot closer to a correct install.These are just minor things Im stressing over and is an easy fix, besides having to forget the view is slightly canted. Im going to leave it alone and see if I forget about it, then possibly revisit to try to make it right. Even with my poor install the peephole view is so much better than the tiny eyeglass with no view. These are possibly just things you notice as not perfect for a bit then forget about it. I went into this thinking "this will be a piece of cake". If I did this to your house, and not mine. I would run away and flee the scene.Ok on second inspection. I live on a hill. Its not canted I just have never really seen through a peephole..This is fine.

Kurzfassung:Schöner und guter Türspion, Lochbohrer nur bedingt zu verwenden.Ausführliche Beschreibung:Einmal eingebaut sieht der Türspion hübsch aus und der Blick durch den Spion ist sehr klar und ich sehe tatsächlich das ganz Treppenhaus.Der Lochbohrer ist allerdings viel zu kurz. Meine Tür ist tatsächlich nur 35mm dick und ich musste schon mit vorgebohrtem Führungsloch, nach schnitzen, bohren vom beiden Seiten und etwas Gewalt um die theoretisch gebohrte Scheibe raus zu stemmen. Es ist mir ein Rätsel wie man damit eine über 50mm dicke Tür durch bekommen soll.

This peephole is great! Let me start off by saying it’s big. Like, way bigger than I’ve ever installed before! Don’t let that scare you off though. The field of view is nice and it looks great on my door! The hole saw that comes with it is great for the installation! Just make sure you mark EXACTLY where you want to start drilling before you start. I drilled a pilot hole first. If you mess this up you’ll have to get a new door, the hole is about an inch in diameter. After the hole is drilled it’s painfully simple to install. Just put the outside part in the hole on the outside. Hold it in place and thread the inside portion from the back. There were no instructions to this peephole, hence my instructions. The cover on the inside is a nice feature too!

Simple to install in general. The case was a bit harder for me as a pre-existing hole made the drill bit less applicable. Using a stepped drill bit instead on a metal door is a bit more problematic than had I had no hole in the first place. That is not the fault of the viewer.Optics are fine and the fit worked well so long as th 1 1/8" or 1.1" hole was placed properly. The ease of use is quite good with the enlarged lens and its optics giving a wide-span view with minimal distortion in the area of most concern. Compared to the limited 5/8" opening prior to this changeover, the view is much better and the inner lid is easy to use.Worth the money.

ce judas est livré avec les outils nécessaires à son installation.il est de bonne qualité et solide.il est gros et on voit très bien au travers... mais aussi un peu dans l'autre sens...heureusement qu'il y a un capot.je vous le recommande