Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktinformation
Haushaltsgeräte
- Waschmaschine
- Wasserreiniger
- Warmwasserbereiter
Medizinprodukte
- Abwasserbehandlung
- Reinigung von Wasser
Land- und Forstbewässerung
- Bewässerung landwirtschaftlicher Flächen
- Pflanzenbau
Industrielle Ausrüstungen
- Wasserwerke
- Dämme
John M
Bewertet in Großbritannien am 17. Dezember 2024
When I tested my unit I primed my line with water then when I engaged the relay the water on the outlet was no where near the same pressure I primed my line to.I'm confused to why.. It's as if it's only opening the solenoid partly. Is this expected behaviour?
J. C. Oldham
Bewertet in Großbritannien am 15. Januar 2023
Arrived quickly, looks nice, all the solenoids work.Resistance of the solenoids is 23.5 Ohms so it draws half an Amp, thus each solenoid guzzles 6 Watts while it is letting water out.The inlet is 3/4 INCH threaded so it will fit on UK outside taps (with a female to female 3/4 inch adapter) and the threads are the same as the Hozlok hose system- so far so good.BUT the output nipples are 11MM pipe with a 12 MM barb. NOBODY SELLS water HOSE WITH AN INTERNAL DIAMETER OF 11MM. There IS a seller on Amazon who sells 7/16 INCH claiming it is 11.5MM. 7/16" is a better fit for 11mm than that, as it is 11.11mm (approx) but the seller is offering a short length of tube for many times what it is worth, it is probably cheaper to buy automotive fuel hose at 7/16" internal diameter.As it happens I may be able to make my solenoid work by attaching suction tubing to the output nipples and then lengthening it by forcing it into 12mm pvc tubing. If I can get any more suction tube.
JBeardon
Bewertet in Großbritannien am 1. Juni 2023
Perfectly servicable and reliable valve. I've got it hooked up to an ESP32 with relay board to direct zone based watering in our greenhouse. Inlet is a standard tap connector thread that accepts a standard garden hose quick connector.The outlets are a whole other story! I have a load of different hoses (gas, water, irrigation, stuff you use in bar cellar etc) and NOTHING fits the outlets without leaking. They are a rediculously stupid 'in between' size. The single barb isn't big enough to grip anything that's close. I tried PTFE tape, Fernox and a lot of swearing! My end solution was a cobble-together using a grommet washer from an electrical cable gland along with a jubilee clip.Once I found this solution, I did order another but it's a pathetic shortcoming.
Produktempfehlungen