Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktbeschreibung des Herstellers
DMc
Bewertet in den USA am20. Februar 2025
Over the years I've gone on the cheap and bought lesser quality tools and have always been disappointed. If I need a tool and Rigid sells it, I know that it'll hold up, and you can get replacement parts, which you can't get on most one and done tools.I've cut copper, galvanised, steel, even schedule 40 pvc, in a pinch, and haven't had any issues with walking, mis-alignment, chipped or rolled cutting wheels.Solid pipe cutter
frederick de chantal
Bewertet in Kanada am 1. März 2025
Very good pipe cutter! I use it all the time and it cuts good.The quality is very good!It's sure more expensive than most pipe cutter but it's clearly the best i used !
فارس
Bewertet in Saudi-Arabien am 3. April 2023
الاداة جيده السعر لا ادري
Dave P.
Bewertet in den USA am15. Mai 2022
I grew up in a Mom & Pop & Sons plumbing business and was cutting and threading pipe long before I could drive a car--and Dad had the wisdom to use mostly RIDGID tools, which he never had to swear at or throw to get them to work properly.But I considered returning this cutter because I also found it hard to keep the 4 wheels on track when starting a cut. Instead, I decided to replace the 2 cutters on the tool body with rollers so that the 2 moveable cutters did all the cutting--and the rollers would hold it on track due to the much greater contact with the pipe. But RIDGID rollers were difficult to find or way too expensive, so my MacGyver idea was to substitute steel flat washers for rollers. Any hardware store will have flat washers that are 1" diameter with a 3/8" hole. Stack 10 into each cutter slot--they'll be a little loose since the pin is 5/16" diameter. The washers will turn freely and keep the cutting wheels tight to the pipe and in perfect alignment. I'm cutting chain link line posts and top rails, and the cuts made with the washer-rollers are perfectly perpendicular to the pipe and started straight on the first turn.I do have one post close to a tree, so I'll need to start the cut using the washers and 2 cutters, then install all 4 cutters to cut the entire circumference of the pipe--but a minor inconvenience since the pins tap out with a small hammer and pin punch or Phillips screwdriver, so that it takes just a few minutes to swap cutters and washer stacks.So, do I get a RIDGID TOOL calendar for this great review?
LUCA
Bewertet in Italien am 3. April 2021
Ottima tagliatubi, perfetta anche per uso intenso.
Produktempfehlungen
35.24€
16 .99 € 16.99€