Ihr Warenkorb ist leer
Ihr Warenkorb ist leerErsatz Umlenkrolle für John Deere. Ersetzt OEM # gx20287. Maxpower Riemenscheiben werden in den USA hergestellt Entspricht oder übertrifft die Original Equipment Spezifikationen.
sanoj
Bewertet in Deutschland am 4. Februar 2024
Die Rolle hat sich schon sehr gut bewährt.
Ken
Bewertet in den USA am24. Mai 2024
Was a perfect fit for my John Deere D140 mower. Seems like OEM quality. Time will tell.
Customer
Bewertet in den USA am4. September 2023
Just the part I needed. Only place I could find this was on Amazon
Falke
Bewertet in Deutschland am 28. Oktober 2021
Gutes Preis- Leistungs- Verhältnis. Maße und Material, wie das Original!
Nicholas Burns
Bewertet in den USA am8. Dezember 2020
I replaced the stock transmission pulley on a John Deere L118 to eliminate squeaks caused by worn bearings. The pulley worked well to renew the drive train.
Eckerle Gerald
Bewertet in Deutschland am 20. Dezember 2020
Das Teil ist nicht schlecht jedoch nicht passend, obwohl bei AMAZON in der Beschreibung angegeben! Deshalb Daumen nach unten!!
petsch40
Bewertet in Deutschland am 14. Juli 2020
Alles super
WILLIAM
Bewertet in den USA am27. September 2019
My 2009 Murray riding mower stopped moving. The motion belt idler pulley was seized up. The product arrived on time and in good condition. The installation took about 20 minutes. My mower is moving again! Note: Make sure you remove the center washer from the old pulley and place it in the new one. If not, it won't fit.
Manfred Nowak
Bewertet in Deutschland am 14. September 2019
der verschleiß ist zu groß
Zenman
Bewertet in den USA am12. September 2013
I own a Murray with a 14.5 Briggs and a 40" deck. One day it would not go into forward or reverse. Upon further examination it was revealed that the original plastic idler had shattered, leaving no tension to the drive belt, so I ordered up one of these and new belts.Although it is an exact replacement, I wish they would have upgraded the product and made it of something a bit sturdier, perhaps metal. I feel this one will probably suffer the same fate as the first one at some point. Therefore, 4 stars.Also, it's sort of on the fiddly side to replace a drive belt on this mower. First you have to drop and remove the deck, which is not too bad, removing a few clips gets that done. Then it's about getting the mower onto ramps and jack stands so you can get under it. Now the real fun begins, involving not only removing the old idler, but separating the steering column and then a bit by the transmission, so that you can feed the new belt into place.On my mower there was a little metal sleeve or reducer that fits in the center bore of the idler so that it fits the shaft mount in my application. Don't lose the old one, or you'll be fabricating.Mow on, my friends!
Produktempfehlungen
34.40€
15 .99 € 15.99€