Ihr Warenkorb ist leer
Ihr Warenkorb ist leerKunde
Bewertet in Deutschland am 8. Februar 2025
Bei Rasenmäher neuem Motorroller und Motorsäge einwandfrei. Bei meinem Oldtimer mit Schwunglicht Magnet-Zündung allerdings völlig absurde Anzeigen. Daher ein Punkt Abzug.
Peter
Bewertet in Kanada am 16. Februar 2025
Programming problems. Followed instructions properly. Will not set up. Avoid.
teresa brame
Bewertet in Großbritannien am 21. August 2024
I use this for lawnmowers, as I repair and service mowers I like to check the revs of the engine. Clip the clip onto the HT lead/spark plug lead and click the on button and it reads precisely! Works perfectly from mower to mower
L
Bewertet in den USA am20. August 2024
5-stars for this little example of Chinese electronics!! I believe this one is different than the slightly cheaper ones so beware if they do not have the red clip for the test lead. I think I got lucky because this was the only one with any clip that would ship overnight.Has replaceable CR2032 Battery from access plugHas decent clip to go on coil or spark plug wire, on about a 3 ft long lead.Display has 10 RPM resolution.I checked at idle and up to 3000 rpm against factory tach on 6 cyl Blazer w/coil wire (3P1R setting) - tachometers agreed exactly and it was stable.I checked at idle and up to 3500 rpm against Autometer Tachometer on 8 cyl race car w/coil wire (4P1R setting) - tachometers agreed exactly and it was stable.Using this as a test tachometer for mapping/checking distributor advance @ RPM in my race car. (Can't see the dash tach while under the hood, and digital is better for this purpose).
martoni
Bewertet in Deutschland am 1. März 2024
Momentan etwas überfordert von den vielen Möglichkeiten des Menüs habe ich einfach die Klemmen an die Zundkerze angebracht und siehe da, es hat sofort die Drehzahl angezeigt.
Produktempfehlungen